Get the ultimate protection from radiant heat with our line of heat barriers.
The Adhesive Backed Heat Barrier protects parts and components from radiant heat. It can be used in applications to protect painted surfaces, plastic parts or any component from the damaging effects of radiant heat.
Adhesive Backed Heat Barrier is made up of woven silica with a flexible aluminized finish. The highly reflective surface of the material is capable of withstanding radiant temperatures up to 2000°F. The adhesive backed side handles direct and continuous temperatures up to 300ºF.
The adhesive backed composite construction material can easily be applied to any surface or wrapped around a hose or wire to make a clean professional appearance.
|13500||12" X 12"||BUY NOW|
|13575||12" X 24"||BUY NOW|
|13575-50||12" X 50'|
|13585||24" X 36"||BUY NOW|
|13590||24" X 48"||BUY NOW|
|13590-50||24" X 50'|
Aluminized Heat Barrier
The Aluminized Heat Barrier is made up of woven silica with a flexible aluminized finish. The highly-reflective surface of the material is capable of withstanding radiant temperatures up to 2000°F. The fabric side can handle temperatures in the range of 350-1200 degrees F.
This product can be installed using standard rivets with a backup washer or weather strip adhesive. The use of clamps or straps such as Thermo-Tec's Snap Strap can be used to hold the blanket in place for manifolds or exhaust systems. This product can be cut to fit.
|14001||40" X 36"||BUY NOW|
|14001-50||40" X 50'|
24 K Heat Barrier
An excellent insulation product, the 24 K Heat Barrier helps protect vital engine components and provides a barrier against radiant heat up to 2000°F. Helps lower intake and under hood temperatures. Easily installs virtually anywhere with an adhesive backing.
|13700||12 in. x 24 in.|
|13775||24 in. x 24 in.|
|13775-50||24 in. x 50 ft.|
|13990||1.5 in. x 15 ft.|
Aramid Heat Barrier
The Aramid Heat Barrier is made from Aramid with a reflective foil finish. The Barrier can withstand up to 3000 degrees F of radiant heat and can withstand direct contact up to 800 degrees F. The product can be installed using standard rivets with a backup washer or our Heavy-Duty Spray Adhesive. The use of clamps or straps such as Thermo-Tec's Snap Strap can be used to hold the blanket in place for applications on manifolds or exhaust systems.
In applications such as a heat shield on the undercarriage above the exhaust the material should be held in place by fasteners as described above. When used as a heat shield, the barrier is installed so the bright metallic surface faces the heat source. When used to retain heat in applications such as exhaust manifolds, the barrier is installed with the fabric side facing the heat. This allows the metallic surface to act as a barrier to prevent the penetration of liquids.
|16850||26" X 40"||BUY NOW|